Motorola BC796D Guida Utente Scaricare il pdf (Pagina 15)

ScanControl

One Program, Multiple Scanners, Made in USA

choices represent the different Trunked modes available for the connected radio type. If

you are mixing a Trunked system along with Conventional frequencies in the same bank

the Trunked frequencies should be programmed into contiguous memory locations in the

bank. Only one Trunked system type

can be programmed per bank.

o CCO – Control Channel Only mode: Control Channel Only mode for a trunked bank is

available on the BC898T, BCT8, BC250D, BC296D, BC785D, BC796D and the

BC780XLT. When this function is activated, trunking is performed using Control

Channel data only. Voice channel frequencies do not have to be programmed into the

radio. This feature only applies to Motorola 800 MHz and 900 MHz systems. You must

choose one of 4 frequency plans (only when 800 MHz systems is selected) before you

begin to Control Channel Trunk. The default, Plan 1, is the most common. Read the

description of the Plans below for details on which may apply for you.

 PLAN 1: Use Plan 1 if the last three digits of ALL the frequencies in use end in

one of the following three digits: 125, 375, 625, or 875 (example: 856.1125,

860.7375, 859.6625, 855.8875).

 PLAN 2: If the frequencies are less than 869.0000 and end in one of the following

three digits (125, 375, 625, or 875) and if ANY other frequencies end in (000,

250, 500, or 750) use Plan 2.

 PLAN 3: If the last three digits of ALL the frequencies in use end in one of the

following three digits (000, 250, 500, or 750) use Plan 3.

 PLAN 4: If the frequencies are less than 866.0000 and end in one of the following

three digits (000, 250, 500, or 750) and if ANY other frequencies end in (125,

375, 625, or 875) use Plan 4.

• Channels Section – Channel data entry fields for all the Channels in the selected Bank.

o Channels: Ch# - Displays the absolute Channel number from 1 to the maximum number

of Channels in the connected radio type. These numbers cannot be edited. Groups of

Channels, 20 Channels per group for the BC95XLT, BC245XLT, BC895XLT, BC898T,

BCT8, BC780XLT, BC250D, BC296D, BC785D and BC796D are displayable within

each Bank Tab. The < Ch# 1 to 20 and Ch# 21 to 40 > buttons (see below) are used to

toggle between the groups in each Bank. Clicking on this Ch# box brings up the

Single Channel Update Screen for individual channel programming.

Figure 8 – Single Channel Update

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 85 86

Nessun commento

Motorola BC796D Guida Utente Pagina 15